Centos修改默认网卡为eth0

修改网卡配置文件中的 DEVICE= 参数的关于 eth0

TYPE=Ethernet
PROXY_METHOD=none
BROWSER_ONLY=no
BOOTPROTO=static
DEFROUTE=yes
IPV4_FAILURE_FATAL=yes
IPV6INIT=yes
IPV6_AUTOCONF=yes
IPV6_DEFROUTE=yes
IPV6_FAILURE_FATAL=no
IPV6_ADDR_GEN_MODE=stable-privacy
NAME=eth0
DEVICE=eth0
ONBOOT=yes
IPADDR=192.168.100.43
NETMASK=255.255.255.0
GATEWAY=192.168.100.1
DNS1=114.114.114.114
~

修改网卡文件名 mv ifcfg-eno16777728 ifcfg-eth0
因 CentOS7 采用 grub2 引导，还需要对 grub2 进行修改，编辑 /etc/default/grub 配置文件，在 GRUB_CMDLINE_LINUX 这个参数后面加入 net.ifnames=0 biosdevname=0

GRUB_TIMEOUT=5
GRUB_DISTRIBUTOR="$(sed 's, release .*$,,g' /etc/system-release)"
GRUB_DEFAULT=saved
GRUB_DISABLE_SUBMENU=true
GRUB_TERMINAL_OUTPUT="console"
GRUB_CMDLINE_LINUX="crashkernel=auto rd.lvm.lv=centos/root rd.lvm.lv=centos/swap
rhgb quiet net.ifnames=0 biosdevname=0"
GRUB_DISABLE_RECOVERY="true"

用 grub2-mkconfig 命令重新生成GRUB配置并更新内核

[root@localhost ~]# grub2-mkconfig -o /boot/grub2/grub.cfg
Generating grub configuration file ...
Found linux image: /boot/vmlinuz-3.10.0-327.el7.x86_64
Found initrd image: /boot/initramfs-3.10.0-327.el7.x86_64.img
Found linux image: /boot/vmlinuz-0-rescue-4dd6b54f74c94bff9e92c61d669fc195
Found initrd image: /boot/initramfs-0-rescue-4dd6b54f74c94bff9e92c61d669fc195.img
done

重启 init 6

文章标题：Centos修改默认网卡为eth0
文章出自：http://azwzsj.com/article/jgjhpg.html

Centos修改默认网卡为eth0

其他资讯